This means your system is running its normal necessary updates, and it shouldn't take more than 20 minutes or half an hour. Recently during one of these routine updates, however, I waited for more than eight hours with the same notification on my screen. I wondered if this was happening because of a particular update, and therefore routine, but that didn't seem to be the case.
I did a hard reboot which under normal circumstances is not a good idea, but I had no other option. After turning back on, it went back to the same configuration process, stuck again. Do not turn off your computer.
This process shouldn't take too long and you should be able to log in normally. If it works, you can then run the necessary updates manually. Switching on a computer system can be done from a number of modes, one of which is Safe Mode. This process will bypass the normal booting sequence of a computer. Before doing any of the following, see if your computer will reboot in Safe Mode. Once you are able to log on, you can repair the problem.
Official cleaning up do not turn off your computer nude photos
You may need to undo the changes that were made during the aborted update. System Restore is built into Windows, and is a way to undo system changes without altering personal files.
If the above solutions fail, you may need to contact a certified manufacturer technician, as there may be hardware issues. Sign in or sign up and post using a HubPages Network account. Comments are not for promoting your articles or other sites.
I just had the same problem and the Update screen had been on for almpst an hour.
I've waited for like 1 whole day for the reverting update thing but sadly Im still stuck on it Hi, I just bought myself a new HP laptop from Argos in my home city of Dublin, Ireland on last Saturday and there is a problem with it.
It gets stuck on the screen saying, "Preparing to configure Windows. Don't turn off your computer" when I selected restart and it won't restart. It takes a very long time to configure Windows. I've been waiting for about an hour.
I am very worried and stressed about it. My new laptop is 2 days old and its doing this? Im getting my dollars back refund dumb idiots who make laptops. Hello, my computer is stuck on configuring please do not turn off computer!
Have experienced this issue on computer that Windows 7 installed on for 6 years when installing May updates. Left computer on for approximately 9. Appears to be just another Microsoft issue with installation of updates on some computers. My lap top is preparing confiugre windows more than 12 hours and it do not shut down.
Please tell me a solution. I've been waiting for like the whole day but it's still like that. It restarts and goes to configuring again. By the way I think his PC is still using Windows 7. I'm afraid that he will scold me.
What should I do?
You can contact a certified technician if the solution provided did not solve your problem. There may be other issues. Its not doing anything! Is there something else I can try? When in safe mode make sure C: In my case I have to increase the size of C: I have virtual environment, if your PC is physical make sure you delete unwanted space from your C: My window 7 has been stucked on the failure to configure page.
I have tried safe mode as directed but it still gets stucked same place. Can any other thing I done with me having to lose my files? If pc continuously 'reverting changes' manually install the available Windows updates one at a time until you find the failing update- troubleshoot individually, or exclude the failing update from the install list.
Windows update reverting changes. Its showing this thing.
What should i do?? Never did a hard restart but was still stuck on the "Preparing to configure Windows Ironic, at this very moment my laptop is stuck on the "Failure Configuring Windows Updates" error message screen for the past 3 hoursand I just discovered that I do not have restore points Cleaning up do not turn off your computer all on that system, as I just installed a new hard drive yesterday.
This means I get to reinstall Windows 7 - all over again. Fortunately, I also have this relic of a desktop Last week I had 10 updates which failed and I had to revert back to an older update.
Now for a week I have tried to install updates of them now because I reverted to back before a service package anyway Reading a windows troubleshoot said to turn off antivirus for one reset then turn back on once configured.
Still failing to configure. Thanks for all comments. I observed that starting some systems from safe mode may not resolve the issue. It is however the primary starting point which has proved useful as attested to many computer users. If every avenue to get it resolved is exhausted, you may need to re-install an operating system.
My laptop said please wait and I waited 20minutes already. Can someone please fix this and tell how to do it and it said restarting but it went back the same problem. Omogiade, thank you so much for posting this. I waited an hour on that stupid screen and your instructions worked perfectly.
Follow the steps I discussed and the problem will be solved. If the problem persist contact Microsoft help desk or perhaps you may need to format your system.
I found an error " failure configuring windows update Then it goes back again in the same error. What exactly is written on your PC screen. Is it the same as this article suggest. You got to do more explanation because there could be other factors, if this proffered solution did not help you. Other product and company names shown may be trademarks of their respective owners.
HubPages and Hubbers authors may earn revenue on this page based on affiliate relationships and advertisements with partners including Amazon, Google, and others.
To provide a better website experience, turbofuture. Please choose which areas of our service you consent to our doing so.
However, if it gets stuck, there are things you can do to fix or work around this issue. Reboot in Safe Mode Switching on a computer system can be done from a number of modes, one of which is Safe Mode. System Restore You may need to undo the changes that were made during the aborted update.
Selected Recommended Restore and Next. Review the restore point, then select Finish. You may be prompted to supply your administrator username and password.
To choose a different restore point, select Choose a Different Restore Point. To review selected restore points, click Scan for Affected Programs, to learn how each restoration would impact your system.
System Restore will revert the system back to a Restore Point, which has been automatically created by Windows. Before running into any update problems, you can also manually create a restore point. A System Properties window will open. You will be prompted to give your restore point a name. Select Create and wait for the restore point to be created.
This way, Cleaning up do not turn off your computer updates won't stack on top of each other, and are less likely to face errors or incompatibilities. Install updates as soon as you receive the notification. Install a reliable antivirus program and malware remover. So I powered it off and on and it got stuck at % complete on Configuring Windows updates, Do not turn off your computer.
So it sat like this. Windows 7 been displaying "Cleaning Up Do Not Turn off Your Computer" at startup after configuring windows updates. This has been.